CAN Gateway Pinout » History » Revision 12
Revision 11 (Adam Klama, 07/30/2024 01:28 PM) → Revision 12/18 (Adam Klama, 08/01/2024 08:08 PM)
# CAN Gateway Pinout |Pin Name | Pin | Pin | Pin Name | |-----------------|-----|-----|------------| | KL30 IN | 1 | 14 | KL31 | | KL30B OUT | 2 | 15 | KL15IN | | PWR6/WAKEUP OUT | 3 | 16 | AN1/PWR1 | | AN2/PWR2 | 4 | 17 | AN3/PWR3 | | AN4/PWR5 | 5 | 18 | AN5/PWR5 | | AN6 | 6 | 19 | AN7 | | AN8/FREQ2 | 7 | 20 | AN9/FREQ1 | | AN10/FREQ4 | 8 | 21 | AN11/FREQ3 | | SENSOR5V | 9 | 22 | sGND | | CAN1H | 10 | 23 | CAN1L | | CAN2H | 11 | 24 | CAN2L | | CAN3H | 12 | 25 | CAN3L | | CAN4H | 13 | 26 | CAN4L | # Pin description Terminal names starting with KL are names according to [DIN 72552](https://en.wikipedia.org/wiki/DIN_72552) ## KL31 KL31 - return to battery- or chassis ground. This pin should be connected with wire of at least 1.5mm<sup>2</sup> ## KL30 IN KL30 - constant battery+ This device is optimized for low power consumption in standby - 0.5mA - it is strongly recommended to keep this terminal on constant bat+ or delayed off. This pin should be wired wit at least 1.5mm<sup>2</sup> ## KL30B OUT KL30B - delayed off battery+. This pin is intended to power the transmission and is capable of supplying 15A. ## KL15IN KL15 - Battery + through ignition switch. This pin should be connected with wire of 0.35mm<sup>2</sup> ## ANx - x between 1 and 8 ANx - Analog input capable of measuring voltages of up to 16V ## ANx - x between 9 and 12 ANx - Analog input capable of measuring voltages of up you to 6V ## PWRy - y between 1 and 5 PWR1 - Low current power output capable with current rating of 0.9A ## FREQz - z between 1 and 4 FREQz - Inputs for speed signals ## sGND sGND - this pin supplies ground, for all sensors connected to analog and frequency inputs. ## SENSOR5V SENSOR5V - this pin supplies 5V to sensors connected to analog and frequency inputs. ## CANxL and CANxH - x between 1 and 4 This pin pairs are used to connect gateway to different CANbus networks. Inside device there are 0805 pads for 120R resistor for termination.